4.6 CYLINDER HEAD COOLANT VENT LINE NOTICE: During installation, ensure that the EGR cooler coolant pipes are seated correctly with the connector pipes. Improperly seated pipes will leak causing engine damage. 7. Install the EGR cooler. Secure the EGR cooler to the bracket with clamps. Torque the clamps to 10 N·m (7 lb·ft). See Figure 4-21. 1. Clamp 6. EGR Cooler Straps 2. Exhaust Gas Inlet Pipe 7. Coolant Vent Line Connection 3. Exhaust Heat Shield Bracket 8. EGR Cooler Bracket 4. Exhaust Heat Shield 9. Lower Coolant Pipe 5. EGR Cooler 10. Upper Coolant Pipe Figure 4-21 EGR Cooler 8.
Rotate the turbocharger inlet elbow back into the correct position and secure the support bracket with two bolts. Torque the bolts to 35 N·m (26 lb·ft). 9. Properly align the coolant pipe and small support bracket to the water pump. Torque the bolts to 35 N·m (26 lb·ft). All information subject to change without notice. 4-32 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION