Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 10. Install the inlet gas pipe to EGR cooler and center pipe of exhaust manifold and secure with clamp halves. Torque clamp bolts to 25 N·m (18 lb·ft). 11. Install the EGR control valve. Refer to section 8.7.2 "Installation of Installation of EGR Control Valve." 12. Install the EGR cooler gas outlet pipe. Refer to section 8.2.2 "Installation of EGR Cooler Gas Outlet Pipe." 13. Install the coolant vent line to the top of the EGR cooler and secure with banjo bolts and washers. Torque banjo bolt to 25 N·m (18 lb·ft). 14. Install the air compressor suction pipe to the mounting bracket and secure with one M10 bolt. Torque the bolt to 35 N·m (26 lb·ft).

See Figure 4-22. Figure 4-22 Air Compressor Suction Supply Bracket 15. Install the radiator support bracket from the top of the EGR cooler bracket and radiator. 16. Refill engine with coolant. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-33