EPA07 MBE 4000 SERVICE MANUAL 5.3 COOLANT Coolant is a mixture of water and antifreeze. Under normal conditions, it is a mixture of 50 percent water and 50 percent antifreeze, but under extreme cold weather conditions, as much as 60 percent antifreeze can be added. For reasons of anticorrosion protection and to raise the boiling point, the coolant must remain in the cooling system all year round. Regardless of mileage, replace the coolant every two years since the degree of corrosion protection gradually drops with time. 5.3.1 Fully Formulated Antifreeze Antifreeze approved for use in the MBE 4000 engine is a mixture of glycol compound (ethylene glycol), and corrosion inhibitors.
Antifreeze containing glycol compounds and corrosion inhibitors is known as fully-formulated antifreeze. NOTE: Do not use propylene glycol. Fully-formulated antifreeze has the following properties: It protects the radiator and engine from freezing. It provides protection against corrosion and cavitation for all components in the cooling system. It raises the boiling point of the coolant. This slows the rate of evaporation, avoiding coolant loss at high temperatures. 5.3.2 Water Water containing no additives is not suitable as a coolant, even if no antifreeze protection is needed.
The water used in the coolant must comply with certain requirements, which are not always satisfied by drinking water. If water quality is inadequate, the water must undergo suitable treatment. In some areas, tap water can contain high levels of dissolved chlorides, sulfates, magnesium, and calcium, causing scale deposits, sludge deposits and/or corrosion. These deposits can damage the coolant pump and allow the engine to overheat. NOTICE: The following types of water are preferred for use in coolant: Distilled water Water purified by reverse osmosis De-ionized water All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 5-7