5.3 COOLANT 5.3.2.1 Coolant Specifications and Concentration To avoid damage to the cooling system, use only an approved corrosion-inhibiting antifreeze. Approved antifreeze must be fully-formulated and comply with the requirements of the Truck Maintenance Council (TMC). Coolant specifications are listed in Table 5-1. Table 5-1 Coolant Specifications When topping off the cooling system after a drop in the coolant level, the concentration of corrosion-inhibiting antifreeze in the coolant must be 50 percent by volume. This affords protection down to a temperature of –37°C (–34°F). The cooling mixing ratio is listed in Table 5-2. NOTE:
If the concentration is too low, there is risk of corrosion/cavitation in the cooling system. Do not increase the proportion (mixing ratio) of corrosion-inhibiting antifreeze beyond 60 percent by volume (this gives the maximum antifreeze protection). Further increases in the mixing ratio would reduce the level of antifreeze protection and adversely affect the coolant's ability to dissipate heat. Table 5-2 Coolant Mixing Ratio 5.3.3 Supplemental Coolant Additives for Fully Formulated Coolant The concentrations of some inhibitors will gradually deplete during normal engine operation. Supplemental Coolant Additives (SCAs) replenish the protection for cooling system components.
The coolant must be maintained with the proper concentration of SCA. Detroit Diesel POWER COOL ® maintenance SCAs are recommended. All information subject to change without notice. 5-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Type of Coolant Requirement Fully-Formulated Ethylene Glycol TMC RP-329 Type "A" Water plus Corrosion Inhibitors Temperature Must Not Fall Below 0°C (32°F) Antifreeze Protection Down to °C (°F) Water % by Volume Corrosion - Inhibiting Antifreeze % by Volume –37 (–34) 50 50 –52 (–62) 40 The cooling mix ratio is Max. 60