1.3 CYLINDER HEAD 12. Using the head bolt impact socket (J–45389), loosen the cylinder head bolts. When all the bolts are loose, remove the bolts from the cylinder head. See Figure 1-5. 1. Fuel Return Line Connection 2. Coolant Line Connection Figure 1-5 Cylinder Head Bolts NOTICE: Do not place the head mating surface down on a flat surface. This would damage the fuel injector nozzles, which protrude slightly. 13. Remove the cylinder head and set it on wooden blocks or on its side. 14. Remove the head gasket from the block and discard gasket. 15. Thoroughly clean the cylinder head, both contact surfaces (head and block), and surfaces inside the cylinder of excess oil, grime, and paint chips.
16. With a straightedge, check the cylinder head surface for warpage. Refer to section 1.3.1.1. Listed in Table 1-1 are warpage limits. Table 1-1 Head Warpage Limits All information subject to change without notice. 1-10 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Limit mm (in.) Over a length of 150 mm (6 in.) 0.15 (0.006)