Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 17. Check the cylinder liner protrusion from the cylinder block. Listed in Table 1-2 are the specifications. Refer to section 1.4.1.3. Table 1-2 Specifications for Measuring Cylinder Liner Protrusion 18. Inspect the cylinder head for cracks or signs of damage. Replace if necessary. 1.3.1.1 Inspection of Cylinder Head Inspection steps are as follows: 1. Remove the cylinder head. Refer to section 1.3.1. 2. Remove the fuel injector. Refer to section 2.6.1. 3. Remove the intake and exhaust valves. Refer to section 1.20.3. 4. Remove the constant throttle valve. Refer to section 1.6.1. 5.

Inspect the contact surface (bottom face) of the cylinder head for warpage, both lengthwise and diagonally. See Figure 1-6. If the gap is larger than 0.15 mm (0.006 in.), machine the cylinder head. 1. Contact Surface 2. Straightedge Figure 1-6 Measuring Cylinder Head Warpage [a] Place a straightedge lengthwise across the cylinder head contact surface (bottom face). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-11 Description Specifications: mm (in.) Cylinder Liner Protrusion from block 0.230-0.330 (0.0090-0.0130) Difference between the four measuring points Max.: 0.02 (0.0008)