1.3 CYLINDER HEAD [b] If there is a gap between the lower edge of the straightedge and the contact surface of the cylinder head that is large enough to let light through, insert a feeler gauge into the gap. [c] Measure the amount of warpage with the feeler gauge and compare it to the value listed in Table 1-3. If the gap is larger than 0.15 mm (0.006 in.), machine the cylinder head. Table 1-3 Cylinder Head Specifications [d] Place the straightedge diagonally across the cylinder head. Repeat the procedure above. 6. Check the cylinder head contact surface for parallelism, at each corner. See Figure 1-7.
If the four measurements deviate by more than 0.1 mm (0.004 inch), machine the cylinder head. Figure 1-7 Measuring Cylinder Head Parallelism [a] Rest the cylinder head on a flat surface, with the contact surface exposed (bottom face up). NOTE: Make sure the head is level before going on with this check. All information subject to change without notice.
1-12 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION What To Measure How To Measure Specifications mm (in.) Maximum Permissible Warpage of Head Mating Surface Lengthwise and Diagonally 0.015 (0.006) Maximum Permissible Parallelism Deviation of Head Mating Surface At Each of the Four Corners 0.1 (0.004) Overall Height of Cylinder Head When New 113.85-114.15 (4.482-4.494) After Machining (Minimum Height) 113.5 (4.47)