Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL [b] Install a dial gauge so that the feeler touches the contact surface with some preload. [c] Fasten the dial gauge and adjust the scale to "0" (zero). [d] Check the reading on the dial gauge. If the reading is larger than 0.1 mm (0.004 in.), machine the cylinder head. [e] Repeat this procedure at each spot marked by an arrow (each corner of the cylinder head). 7. Measure the overall height of the cylinder head. See Figure 1-8. Replace the head if below the minimum height. If above the maximum height, machine the head down to the maximum height listed in Table 1-3. 1. Cylinder Head 2. Exhaust Valve 3.

Intake Valve Figure 1-8 Measuring Cylinder Head Height 1.3.1.2 Machining of Cylinder Head Machining steps are as follows: 1. Machine the contact surface of the cylinder head, to correct any problems found during inspection. [a] If rejected for warpage, check warpage again until it is within specifications. [b] If rejected for lack of parallelism, check parallelism again until it is within specifications. 2. After machining, check again the overall height of the cylinder head. 3. Install the constant throttle valve. Refer to section 1.6.2. 4. Install the intake and exhaust valves. Refer to section 1.20.4. 5. Install the fuel injector. Refer to section 2.6.2. 6. Install the cylinder head.

Refer to section 1.3.2. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-13