1.3 CYLINDER HEAD 1.3.1.3 Testing of Cylinder Head Testing steps are as follows: 1. Remove the exhaust brake compressed-air line from the exhaust brake cylinder. 2. Remove the v-band clamp connecting the exhaust pipe to the brake valve housing. 3. Remove the turbocharger. Refer to section 6.7.2. 4. Remove the exhaust manifold. Refer to section 7.1.1. 5. Remove the cylinder head. Refer to section 1.3.1. 1. Test Plugs 5. Coolant line Hole 2. Safety Retaining Washer 6. Sealing Washer 3. Cast Iron Plugs 7. Air Test Plug Adaptor 4. Firedeck 8. Protective Sleeve Figure 1-9 Cylinder Head Leak Test Kit J-45982–8 6. Remove the fuel injector nozzle from the cylinder head. Refer to section 2.6.1. 7.
Using the Cylinder Head Leak Test Kit (J-45982–8 part of Head and Block Leak Test Kit J-45982), install two plugs into the appropriate holes on firedeck of cylinder head. Tighten the nuts to expand the plugs. See Figure 1-9. 8. Install the air test plug adaptor into the coolant line hole on the top of the cylinder head. See Figure 1-9. 9. Place the safety retaining washer over the test plug adaptor. See Figure 1-9. All information subject to change without notice. 1-14 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION