EPA07 MBE 4000 SERVICE MANUAL 10. With the shutoff valve on the regulator in the off position, set the regulator to zero pressure by pulling up on the adjusting knob and turning counter-clockwise. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 11. Connect a shop air supply to the pressure regulator (J-45982–7 part of kit J–45982) then turn the shutoff valve to the ON position. 12. Adjust the system pressure by pulling up on the adjusting knob and turn clockwise until a pressure of reading on the gauge is 200 kPa (29 psi). 13.
Connect the Regulator and Gage (J-45982–7 part of kit J–45982) to the air test plug on the cylinder head. See Figure 1-9. 14. Check for leaks around the test plugs and fittings with a soapy water solution. Repair any leaks found. 15. With a soapy water solution check the cup plugs on the sides of the cylinder head and the injector nozzle protective sleeve area. [a] If the cup plug(s) are leaking, replace the plug(s). [b] If the injector protective sleeve is leaking, replace the protective sleeve O-ring. Refer to section 2.7.1. 16. Close the air supply and watch the pressure gauge for 30 seconds.
If the air pressure drops during this time the cylinder head has leakage from the cooling passages and is not suitable for reuse. 17. Remove the test equipment from the cylinder head and repeat leak test for any additional cylinder heads. 18. Install the fuel injector nozzle in the cylinder head. Refer to section 2.6.2. 19. Install the cylinder head. Refer to section 1.3.2. 20. Install the exhaust manifold. Refer to section 7.1.2. 21. Install the turbocharger. Refer to section 6.7.3. 22. Install the air line on the exhaust brake cylinder. 23. Clean the sealing surfaces on the exhaust pipe and brake valve housing. 24. Slide the exhaust pipe and clamp over the end of the housing.
Tighten the clamp. 1.3.2 Installation of Cylinder Head Installation steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-15