Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.3 CYLINDER HEAD NOTICE: Be sure the carbon scraper ring is seated in the groove on the top part of the cylinder liner before installing a new cylinder head gasket and the cylinder head, component damage will result. 1. Cylinder Liner 3. Installed Piston 2. Carbon Scraper Ring 4. Carbon Scraper Ring located in groove in cylinder liner Figure 1-10 Carbon Scraper Ring NOTICE: The cylinder head gasket on the engine has a thick rubber seal at the coolant inlet and outlet ports. The cylinder head has a machined 1.3 mm recess at the mating surface. Correct gasket with head configuration must be used. Failure to use the correct gasket could result in engine failure. 1. Install a new head gasket.

Match up the holes in gasket with those in the cylinder block and place the head gasket over the guide pins in the block. 2. Position the cylinder head on the head gasket. Make sure the head is seated onto the guide pins. All information subject to change without notice. 1-16 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION