Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

6.1 AIR INTAKE ELBOW AND GRID HEATER 5. Remove the elbow and metal gasket from gas mixer housing. See Figure 6-2. 6. Disconnect the harness connector and electrical connection on the grid heater. 7. Remove four bolts and washers securing the grid heater to the air inlet elbow. Remove the grid heater and gasket. Discard the gasket. See Figure 6-2. 8. If necessary, remove the cover plate and seal ring from the air intake elbow by removing four bolts. Discard seal ring. See Figure 6-2. 6.1.2 Installation of Air Intake Elbow and Grid Heater Installation steps are as follows: 1. If removed, install the cover plate and seal ring on the air intake elbow and secure with four bolts (M8 x 25mm).

Torque the bolts to 25 N·m (18 lb·ft). See Figure 6-2. 2. Install the grid heater and gasket and secure with four bolts and washers. Torque the bolts to 25 N·m (18 lb·ft). See Figure 6-2. 3. Connect the harness connector and electrical connections on the grid heater. Torque the nut for the battery supply connection to a maximum of 25 N·m (18 lb·ft). See Figure 6-3. 1. Battery Ground 3. Battery Supply (+12 V) 2. Connector to MCM (part of engine harness) Figure 6-3 Grid Heater Electrical Connections 4. Install the air intake elbow and metal gasket on the EGR gas mixer and secure with four locking nuts (M10). Torque the nuts to 25 N·m (18 lb·ft). See Figure 6-2. 5.

Loosely secure the support bracket to the air intake elbow with a bolt (M10 x 25 mm). See Figure 6-2. 6. Secure the support bracket to the alternator bracket with two isolators, spacer and bolt (M10 x 35 mm). Torque the bolts to 60 N·m (44 lb·ft). See Figure 6-2. All information subject to change without notice. 6-6 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION