6.6 INTAKE AIR TEMPERATURE/PRESSURE SENSOR 6.6.2 Installation of Intake Air Pressure/Temperature Sensor Installation steps are as follows: 1. Install the intake air temperature/pressure sensor in the EGR mixer housing and secure with two screws. Tighten the screws to 10 N·m (7 lb·ft). See Figure 6-12. 2. Connect the electrical connector to the sensor. See Figure 6-12. 3. Lower the hood and remove the chocks from the rear tires. To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. ENGINE EXHAUST NOTICE:
Whenever the intake air temperature/pressure sensor is replaced the air mass flow of the engine must be re-calibrated to ensure proper engine EGR and smoke control operation. 4. Start and run the engine. 5. Connect DDDL® 7.0 and turn the ignition to the "ON" position, code SPN 132 FMI 13 (Air Mass Adaptation Required) will appear. To clear the code run the Air Mass Adaptation service routine. 6. If any other codes appear, refer to the MBE 4000 DDEC VI Troubleshooting Guide. 7. Shut down the engine. All information subject to change without notice. 6-24 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION