Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 6.6 INTAKE AIR TEMPERATURE/PRESSURE SENSOR The following sections support the intake air temperature and pressure sensor. 6.6.1 Intake Air Temperature/Pressure Sensor Removal Removal steps are as follows: NOTE: The intake air temperature/pressure sensor is located on top of the EGR gas mixer housing. PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Apply the parking brakes, shut down the engine, and chock the rear tires. Tilt the hood. 1. Bolts 2. Intake Air Temperature/Pressure Sensor Figure 6-12 Intake Air Pressure/Temperature Sensor 2.

Disconnect the electrical connector to the sensor located on top of the gas mixer housing. See Figure 6-12. 3. Remove the screws attaching the intake manifold pressure/temperature sensor, then remove the sensor from the EGR gas mixer housing. See Figure 6-12. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-23