Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

6.5 ELECTROSTATIC OIL SEPARATOR, CRANKCASE SEPARATOR, AND OIL SEPARATOR DRAIN LINE 2. Install hose and clamp on lower oil separator drain tube line. Slide the lower drain tube up from the bottom of the block between the trim cover frame between cylinders five and six. See Figure 6-11. 3. While holding lower oil drain line up install a hose clamp over the hose, then insert the upper line into the hose. The upper banjo fitting should face outward and the lower fitting should be parallel with the cylinder block. Tighten the hose clamps securely. 4. Secure lower end of the oil separator drain line to the oil pan with a banjo bolt and new washers. Torque the banjo bolt to 50 N·m (37 lb·ft).

See Figure 6-11. 5. Secure the upper end of the oil separator drain line to the bottom rear of the air intake manifold with a banjo bolt and new washers. Torque the banjo bolt to 35 N·m (26 lb·ft). See Figure 6-11. All information subject to change without notice. 6-22 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION