Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 6.5.5 Removal of Oil Separator Drain Line Removal steps are as follows: 1. Banjo Fitting 5. Banjo Bolt 9. Clamp 2. Adaptor Fitting 6. Bolt 10. Hose Clamps 3. Seal Ring 7. Screw 11. Hose 4. Washers 8. Bracket 12. Air Intake Manifold Figure 6-11 Oil Separator Drain Line 1. Remove the banjo bolt and washers securing the crankcase breather drain line to the bottom rear of the air intake manifold. Discard washers. See Figure 6-11. 2. Remove the banjo bolt and washers securing the oil separator drain line to the side of the oil pan and remove the line. Discard the washer. See Figure 6-11. 3.

Pull the oil drain line upward and remove two hose clamps and hose from the drain tube. Remove the upper and lower drain tube line. See Figure 6-11. 4. If necessary, adaptor fitting and seal ring. Discard seal ring. See Figure 6-11. 6.5.6 Installation of Oil Separator Drain Line Installation steps are as follows: 1. If removed, install drain line adaptor fitting and new seal ring in the side of the cylinder block. Torque the fitting to 25 N·m (18 lb·ft). See Figure 6-11. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-21