Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

6.5 ELECTROSTATIC OIL SEPARATOR, CRANKCASE SEPARATOR, AND OIL SEPARATOR DRAIN LINE Electrical Shock Hazard High voltage can remain inside the Electrostatic Oil Separator after removal. Wait 30 minutes after turning off the ignition before removing the separator. Never touch parts through ventilation openings or impeller opening with finger or conductive items (e.g. screwdriver or wire). High voltage can remain inside the Electrostatic Oil Separator for up to 12 hours after the ignition is turned off. 3. Remove two bolts securing the separator to the side of the cylinder block. See Figure 6-10. 4. Remove the separator and seal ring. Discard the seal ring. See Figure 6-10. 5.

If necessary, remove the hose and clamp from the crankcase pre-separation. Inspect the hose and replace if damaged. 6. If necessary, remove the connector fitting and seal ring from the bottom of the air intake manifold. Discard the seal ring. See Figure 6-10. 6.5.4 Installation of Crankcase Separator Installation steps are as follows: 1. If removed, install the hose and clamp on the crankcase pre-separation. See Figure 6-10. 2. Install a new seal ring on the crankcase separator. See Figure 6-10. 3. Attach the separator to the side of the cylinder block by sliding into hose on the bottom of the air intake manifold and secure with two bolts (M8 x 15 mm). Torque the bolts to 25 N·m (18 lb·ft).

Tighten the clamp securely. See Figure 6-10. 4. Install the rear side trim cover and secure with three bolts (M8 x 18mm). Torque the bolts to 12 N·m (9 lb·ft). All information subject to change without notice. 6-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION