EPA07 MBE 4000 SERVICE MANUAL 4. Connect the electrical connector to the Electrostatic Oil Separator. 5. Install the rear engine trim cover and secure with two bolts (M6 x 18 mm). Torque the bolts to 12 N·m (9 lb·ft). 6. Install the crankcase breather pipe. Refer to section 6.4.4. 6.5.3 Removal of Crankcase Separator Removal steps are as follows: 1. Remove the rear side trim cover. 1. Seal Ring 4. Air Intake Manifold 7. Oil Preseparator 2. Hose 5. Seal Ring 8. Bolt 3. Connector Fitting 6. Clamps Figure 6-10 Oil Separator 2. Loosen hose clamp on the bottom of the air intake manifold and crankcase separator. See Figure 6-10. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-19