Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

6.5 ELECTROSTATIC OIL SEPARATOR, CRANKCASE SEPARATOR, AND OIL SEPARATOR DRAIN LINE 6.5.2 Installation of Electrostatic Oil Separator Perform the following to install the Electrostatic Oil Separator. Electrical Shock Hazard High voltage can remain inside the Electrostatic Oil Separator after removal. Wait 30 minutes after turning off the ignition before removing the separator. Never touch parts through ventilation openings or impeller opening with finger or conductive items (e.g. screwdriver or wire). High voltage can remain inside the Electrostatic Oil Separator for up to 12 hours after the ignition is turned off. 1.

If damaged, install new isolator spacers and seal rings on the Electrostatic Oil Separator. Lightly coat the isolator spacers and seal rings with clean engine oil prior to installing in the air intake manifold. See Figure 6-9. 1. Isolator Spacers 2. Seal Rings Figure 6-9 Electrostatic Oil Separator Isolator Spacers and Seal Rings 2. Install a new seal ring on pressure regulator valve. See Figure 6-7. 3. If removed, install the oil separator into the housing in the air intake manifold and secure with two screws (M6 x 20 mm). Torque the screws to 10 N·n (7 lb·ft). See Figure 6-7. All information subject to change without notice. 6-18 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION