Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 6.7.3 Installation of Turbocharger Installation steps are as follows: 1. Inspect the turbo inlet hose, turbocharger outlet pipe, and the oil supply and return lines for restrictions or foreign objects. 2. Using new nuts, install the exhaust housing on the turbocharger (if removed). Torque the nuts 50 N·m (37 lb·ft). 3. Install the two removed studs into the turbocharger. Torque the studs to 50 N·m (37 lb·ft). 4. Install the turbocharger on the exhaust manifold center section. [a] Coat four new prevailing torque locknuts with a light coating of high temperature grease.

[b] Make sure that the mating surfaces of the turbocharger and the exhaust manifold are clean and free of damage. [c] Position the turbocharger over the mounting studs on the exhaust manifold. [d] Install the four nuts and torque to 50 N·m (37 lb·ft). 5. Attach the oil return line to the turbocharger and the cylinder block. [a] Install a new gasket where the end flange of the return line meets the turbocharger. [b] Install the mounting bolts through the holes in the end flange. Torque the bolts to 25 N·m (18 lb·ft). [c] Connect the return line fitting to the side of the engine block. Torque the line fitting to 50 N·m (37 lb·ft)). 6.

Fill the bearing housing with clean engine oil through the oil inlet port. Turn the turbocharger wheel several times to coat the bearings with oil. NOTE: If the turbocharger wheel cannot be spun freely by hand or if there is any indication of rubbing or scraping, determine the reason before starting the engine. One cause of wheel rubbing is a misaligned turbocharger housing. 7. Connect the oil supply line to the turbocharger. [a] Install a new gasket where the end flange of the supply line meets the turbocharger. [b] Install the mounting bolts through the holes in the end flange and the heat shield bracket. Tighten the bolts to 25 N·m (18 lb·ft).

[c] Install two new seal rings on the banjo fitting at the other end of the supply line. [d] Install the banjo bolt attaching the supply line to the cylinder block. Tighten the bolt to 35 N·m (26 lb·ft). 8. Connect the coolant lines to the Doser Block Assembly with banjo bolts and new washers. Torque the banjo bolts to 25–30N·m (18–22 lb·ft). 9. Attach the air intake elbow to the turbocharger. Tighten the clamp to 10 N·m (89 lb·in.). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-33