EPA07 MBE 4000 SERVICE MANUAL 6.8 WASTEGATE ACTUATOR The following explains the removal and installation of the wastegate actuator. 6.8.1 Removal of Wastegate Actuator Remove as follows: 1. Wastegate Actuator 5. Adjusting Rod Jam Nut (M8) 2. Heat Shield 6. Adjusting Rod 3. Actuator Bracket 7. E-Clip 4. Hex Nuts (M6) 8. Wastegate Swing-Arm Figure 6-19 Turbocharger Actuator Components Removal is as follows: NOTE: This procedure utilizes the vehicle compressed air system. For removal, installation, and adjustment, ensure the system maintains minimum 90 psi. 1. Shut off the engine, apply the parking brake, chock the wheels, and perform any other applicable safety steps. 2.
Remove the turbocharger. Refer to section 6.7.2. 3. Loosen the jam nut on the wastegate adjusting rod. 4. Remove the two nuts securing the actuator to the actuator bracket. 5. Remove and discard the E-clip holding the adjusting rod onto the actuator swing-arm pin. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-35