6.8 WASTEGATE ACTUATOR 9. With the wastegate in the fully closed position, adjust the free length of the adjusting rod by rotating it, so that the adjusting rod hole lines up with the wastegate swing-arm pin. NOTE: It is critical that the swing-arm remains in the closed position and the actuator rod is not moved in or out of the actuator during the adjustment. If the rod is moved in or out, it will slowly return to the correct position and must be readjusted. See Figure 6-21. Figure 6-21 Wastegate Swing-Arm in Closed Position All information subject to change without notice. 6-38 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION