Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 9. Remove the twelve bolts and spacers securing the three piece exhaust manifold assembly to the cylinder heads. See Figure 7-5. 1. Exhaust Manifold Gaskets (qty 3) 6. V-Band Clamps 2. Exhaust Manifold End Pieces 7. Adaptor 3. Exhaust Manifold Center Piece with Engine Brake, Bottom Plate, Brake Components 8. Bolts (qty 12) 4. Bellows 9. Spacers (qty 12) 5. Sleeve Figure 7-5 Exhaust Manifold Components 10. Remove the exhaust manifold assembly as a unit from the engine and place it on a workbench. 11. Remove the six mounting bolts from the upper heat shield. Remove the upper heat shield. 12. Remove the bolts securing J-48670–1 and J-48670–2 to the engine. 13.

Remove the V-band clamps securing the two end exhaust manifold sections to the center exhaust manifold section. Remove the two end sections. 14. Remove the sleeves from the exhaust manifold. See Figure 7-5. 15. Visually inspect the sleeves and bellow connectors for damage. Replace components as necessary. 7.1.2 Installation of Exhaust Manifold Assembly Installation steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-7