Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 2. Disconnect the compressed air pipe between inlet connection installed at the EPV and brake gate actuator. See Figure 7-23. 1. Bolts 7. EPV Mounting Bracket Bolts 2. EPV (Electronic Proportional Valve) 8. EPV Mounting Bracket 3. Connector Fitting 9. Washers 5. Banjo Bolt 11. Brake Gate Solenoid Line 4. Wastegate Actuator Line 10. Banjo Bolt 6. Washers Figure 7-23 Electronic Proportional Valve 3. Remove the brake gate solenoid. Refer to section 7.2.7. 4. Disconnect the inlet and outlet connections at EPV pressure regulating valve. 5.

Remove the threaded connector, banjo fitting and washers Discard washers. See Figure 7-23. 6. Remove the two bolts securing the EPV valve to the mounting bracket. See Figure 7-23. 7. Remove the two bolts that hold the EPV mounting bracket to the block. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-27