EPA07 MBE 4000 SERVICE MANUAL 8.1 EGR GAS INLET PIPE The following sections cover the removal and installation of the Exhaust Gas Recirculation (EGR) gas inlet pipe. 8.1.1 Removal of EGR Gas Inlet Pipe Removal steps are as follows: 1. Bolts 9. Insert 2. Rear Mounting Bracket 10. EGR Gas Inlet Pipe from Exhaust Manifold 3. Clamp 11. Clamp 4. EGR Gas Inlet Pipe to EGR Cooler 12. Flanged Nut * 5. Seal 13. Bolt 6. Flanged Nut * 14. Bolt 7. Clamp Halves 15. Bracket 8. Bolts 16. Bolt * Use high temperature resistant hardware only Figure 8-1 EGR Gas Inlet Pipe and Related Components 1. Remove the two bolts from the clamp securing the gas inlet pipe to the mounting bracket at the rear of the engine.
See Figure 8-1. 2. Loosen the bolt securing the rear mounting bracket to the rear engine lifting bracket. See Figure 8-1. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 8-3