8.1 EGR GAS INLET PIPE 3. Remove the bolt from the clamp (near bellows) securing the EGR gas inlet pipe to mounting bracket attached below the rear exhaust manifold. See Figure 8-1. 4. Loosen the two bolts securing the mounting bracket to the exhaust manifold. 5. Remove the two bolts and the two nuts from the clamp halves securing the two components of the EGR gas inlet pipe to the exhaust manifold. See Figure 8-1. 6. Remove the two bolts and the two nuts from the clamp halves securing the EGR gas inlet pipe to the EGR cooler and remove the pipe and two gaskets attached to the EGR cooler. Discard the gaskets. See Figure 8-1. 7.
Loosen the nut securing the EGR gas inlet pipe to the threaded insert on the exhaust manifold and remove the gas inlet pipe. See Figure 8-1. 8.1.1.1 Inspection of Insert Inspection steps are as follows: 1. Clean the insert threads using a wire brush. 2. Visually inspect the insert threads for wear and cracks. [a] If the threads are not damaged, refer to section 8.1.2. [b] If the threads are damaged replace the insert, refer to section 7.1.1 for replacement procedure. NOTE: When the insert has been replaced, refer to section 8.1.2. 8.1.2 Installation of EGR Gas Inlet Pipe Installation steps are as follows: All information subject to change without notice.
8-4 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION