Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 8.3 EGR COOLER AND SUPPORT BRACKET The primary purpose of the EGR cooler is to cool the engine exhaust gases. 8.3.1 Removal of EGR Cooler Removal steps are as follows: 1. Drain the cooling system. 2. Disconnect the coolant vent line located on top of the EGR cooler by removing the banjo bolt and two washers. Discard the washers. 3. Remove the bolts securing the air compressor suction supply bracket to the EGR cooler. See Figure 8-4. 1. Air Compressor Suction Supply Bracket 2. Bolts Figure 8-4 Air Compressor Suction Supply Bracket 4. Remove the four bolts securing the air inlet bracket. Rotate the turbocharger inlet elbow away form the engine. NOTE:

Do not remove the air inlet elbow. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 8-9