Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

8.3 EGR COOLER AND SUPPORT BRACKET NOTICE: During installation, ensure that the EGR cooler water pipes are seated correctly with the connector pipes. Improperly seated pipes will leak causing engine damage. 4. Install the EGR to the EGR cooler support bracket. Secure the EGR cooler to the bracket with clamps. Torque the clamps to 10 N·m (7 lb·ft). See Figure 8-10. 1. EGR Cooler Clamps 4. EGR Cooler Support Bracket 2. Clamp Pieces 5. Cylinder Heads 3. EGR Cooler Figure 8-10 EGR Cooler 5. Reconnect the turbocharger inlet elbow and secure the support bracket with two bolts. Torque the bolts to 35 N·m (26 lb·ft). 6. Properly align the coolant pipe and small support bracket to the water pump.

Torque the bolts to 35 N·m (26 lb·ft). 7. Install the inlet gas pipe to EGR cooler and secure with clamp halves. Torque clamp bolts to 25 N·m (18 lb·ft). 8. Install the air compressor suction pipe to the mounting bracket and secure with one M10 bolt. Torque the bolt to 35 N·m (26 lb·ft). 9. Install the EGR control valve. Refer to section 8.7.2. 10. Install the EGR cooler gas outlet pipe. Refer to section 8.2.2. All information subject to change without notice. 8-16 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION