EPA07 MBE 4000 SERVICE MANUAL 11. Install the coolant vent line to the top of the EGR cooler and secure with banjo bolts and washers. Torque banjo bolt to 25 N·m (18 lb·ft). 12. Refill engine with coolant. 8.3.3 Removal of EGR Cooler Support Bracket Removal steps are as follows: 1. Disconnect the fuel line and two coolant lines from Doser Block Assembly at the turbocharger. 2. Disconnect the two coolant lines from Doser Block Assembly at the turbocharger by removing banjo bolts and washers. Discard the washers. 3. Remove the turbocharger. Refer to section 6.7.2. 4. Remove the exhaust manifold. Refer to section 7.1.1. 5. Remove the EGR cooler. Refer to section 8.3.1. 6.
Remove the EGR cooler support bracket from the side of the cylinder heads. by removing six M10 x 40 mm bolts. 8.3.4 Installation of EGR Cooler Support Bracket Installation steps are as follows: NOTE: Exhaust manifold gaskets will have to be installed before the EGR cooler support bracket can be installed. Refer to section 7.1.2. 1. Install the exhaust manifold guide studs into the cylinder heads 1 through 4 and mount two exhaust manifold gaskets. 2. Attach the EGR cooler support bracket to the side of the cylinder heads and secure with six bolts (M10 x 40 mm). Remove guide studs and torque the bolts to 50 N·m (36 lb·ft). 3. Install the turbocharger. Refer to section 6.7.3. 4.
Install the exhaust manifold. Refer to section 7.1.2. 5. Install the EGR cooler. Refer to section 8.3.2. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 8-17