8.4 EGR COOLER HEAT SHIELD AND MOUNTING BRACKET 8.4 EGR COOLER HEAT SHIELD AND MOUNTING BRACKET The following sections cover EGR cooler heat shield and mounting bracket removal and installation. 8.4.1 Removal of EGR Cooler Heat Shield and Mounting Bracket Removal steps are as follows: 1. Remove three bolts M8 x 12 securing the heat shield to mounting bracket and remove shield. 2. Remove the bolt to the bracket securing the EGR gas inlet pipe to the mounting bracket. 3. Remove bolt M10 x 20 mm securing the bracket to the cylinder head and remove bracket. 8.4.2 Installation of EGR Cooler Heat Shield and Mounting Bracket Installation steps are as follows: 1.
Install bolt M10 x 20 mm and secure the mounting bracket to the cylinder head . Torque the bolt to 35 N·m (26 lb·ft). 2. Using three bolts M8 x 12 secure the heat shield to mounting bracket. Torque the bolt to 25 N·m (18 lb·ft). 3. Install the bolt in the bracket and secure the EGR gas inlet pipe to the mounting bracket. Torque the bolt to 25 N·m (18 lb·ft). All information subject to change without notice. 8-18 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION