EPA07 MBE 4000 SERVICE MANUAL 8.5 EGR COOLER COOLANT INLET TUBE Exhaust gas cooling is accomplished by the flow of exhaust gases through the EGR cooler tubes. 8.5.1 Removal of EGR Cooler Coolant Inlet Tube Removal steps are as follows: 1. Drain the engine coolant. 2. Remove the two bolts mounting the lower coolant inlet pipe to the block and remove the bracket bolt, just below the connector pipe, which attaches the lower coolant inlet pipe to the block. Remove gasket and discard. See Figure 8-11. 1. Bolts 5. Connector Pipe 2. Gasket 6. Bolt 3. Upper Coolant Inlet Pipe 7. Lower Coolant Inlet Pipe 4. EGR Cooler Figure 8-11 Coolant Inlet Pipe 3.
Pull down on the lower coolant inlet pipe to loosen it from the EGR cooler pipe. Remove the pipe and connector pipe. See Figure 8-11. NOTE: Have a container nearby to drain any unused coolant from the inlet pipes. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 8-19