Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

8.5 EGR COOLER COOLANT INLET TUBE 8.5.2 Installation of EGR Cooler Coolant Inlet Tube Installation steps are as follows: 1. Coat the connector pipe on the EGR cooler inlet pipe with International Product Corporation Rubber Lubricant Emulsion (P-80) and insert the connector pipe and inlet pipe into the EGR cooler. See Figure 8-11. 2. Secure the EGR coolant inlet pipe to the side of the cylinder block with two bolts and new gasket. Torque the bolts to 35 N·m (26 lb·ft). See Figure 8-11. 3. Install the removed coolant. All information subject to change without notice. 8-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION