EPA07 MBE 4000 SERVICE MANUAL 1.4 CYLINDER BLOCK The cylinder block has integrated oil and water channels. The upper section of the cylinder bore is induction-hardened. The cylinder block has additional ribs for strength and an improved casting design in the area of the high pressure unit pumps. A flange was added to the left side of the cylinder block for the pre-separator crankcase breather. The purpose of the cylinder liner with an additional sealing ring is to prevent high mileage coolant leakage due to wear in the balcony area of the cylinder block. The ring will keep the coolant away from the balcony area. This service procedure applies to all models of the MBE 4000 engine.
This procedure describes the steps needed to service the engine with the installation of the new design liner with the D-ring seal. 1.4.1 Removal of Cylinder Liner Removal steps are as follows: 1. Remove the piston. Refer to section 1.19.1. 2. Using a paint pen, mark the position of the cylinder liner in the cylinder block. Mark both the cylinder liner and the block. Then make another set of marks 90 degrees from the first set, in a clockwise direction. See Figure 1-13. NOTE: If the same cylinder liner is used again, it must be installed at an offset of 90 degrees from its last position. This reference will not be needed if the cylinder liner is being replaced. 1. Cylinder Block 2.
Cylinder Liner Figure 1-13 Mark the Cylinder Liner All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-21