9.2 ALTERNATOR/AIR CONDITIONING COMPRESSOR BRACKET 9.2 ALTERNATOR/AIR CONDITIONING COMPRESSOR BRACKET The alternator/air conditioning compressor bracket is located at the front left side of the engine and is used to mount the alternator and the air conditioning compressor. 9.2.1 Removal Alternator/Air Conditioning Compressor Bracket Removal steps are as follows: 1. Disconnect the electrical connections at the alternator. 2. Remove the main drive poly-vee belt. Refer to section 9.1.1. 3. Disconnect the electrical connections and remove the air conditioning compressor. Refer to OEM guidelines. 4. Remove bolts securing the alternator to the mounting bracket and remove the alternator. 5.
Remove the bolts securing the air conditioning compressor to the bracket. 6. Remove three bolts from the front of the bracket. 7. Remove four bolts from the side of the bracket and remove the bracket. 9.2.2 Installation of Alternator/Air Conditioning Compressor Bracket Install the alternator/air conditioning compressor bracket as follows: 1. Loosely install three bolts (M12 x 45 mm) in the front of the alternator/air conditioning compressor bracket to the front left side the cylinder block to secure the bracket. See Figure 9-8. 2. Loosely install two bolts (M12 x 30 mm and M12 x 35 mm) in the upper holes of the bracket. See Figure 9-8. All information subject to change without notice.
9-12 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION