Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1. Release the tension on the main drive belt (alternator, coolant-pump, and/or AC compressor), as required. Refer to section 9.1.1 for detailed instructions. 2. With belt tension relaxed, remove the belt from contact with the idler pulley. 3. Release the tensioning pulley. 4. Remove the cover from the idler pulley. 5. Remove the socket-head bolt fastening the pulley to the mounting pad. 6. Remove the pulley from the mounting pad. 9.1.8 Installation of Idler Pulley Installation steps are as follows: 1. Position the pulley on the mounting pad, as removed. 2. Secure the pulley with the socket-head bolt. Tighten the bolt 45 N·m (33 lb·ft). 3.

Release the tension on the belt tensioner. Refer to section 9.1.1 for detailed instructions. 4. Position the belt around the new pulley. 5. When the belt is in place, restore the tension on the drive belt. Refer to section 9.1.1 for detailed instructions. 6. Install the idler pulley cover. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 9-11