Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

9.1 DRIVE BELTS 4. Remove the belt tensioner and tensioner pulley from the mounting pad on the cylinder block. 9.1.6 Installation of Belt Tensioner Installation steps are as follows: 1. Align the guide pins on the belt tensioner with the holes in the mounting pad. 2. Position the belt tensioner to the mounting pad and secure in place with the mounting bolt. Tighten the bolt to 50 N·m (37 lb·ft). 3. Release the belt tensioner to allow the belt to be installed. Refer to section 9.1.2. 4. Install the drive belt on the pulleys, as removed. 5. Restore the tension on the drive belt. 9.1.7 Removal of Idler Pulley Removal steps are as follows: NOTE: This procedure works for all idler pulleys.

To identify the correct pulley, see Figure 9-7. 1. Mounting Bolt 4. Fan Idler Pulley #2 2. Main Drive Belt Idler Pulley 5. Fan Idler Pulley #1 3. Coolant Pump Inlet Pipe Figure 9-7 Idler Pulleys All information subject to change without notice. 9-10 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION