EPA07 MBE 4000 SERVICE MANUAL 11.1 AIR COMPRESSOR FLANGE The air compressor flange is attached to the air compressor housing. Perform the following procedures for removal and installation of the air compressor flange and O-ring. 11.1.1 Removal of Air Compressor Flange Remove as follows: 1. Shut off engine and apply the parking brake, chock the wheels, disconnect vehicle battery power, and perform any other applicable safety steps. 2. Remove the two bolts attaching the power steering pump to the air compressor. NOTE: Do not remove the power steering lines. Tie up the lines and move the pump out of the way. 1. Power Steering Pump Mounting Bolt 5. Air Compressor Housing 2. Power Steering Pump 6.
Air Compressor Mounting Bolt 3. O-ring 7. Air Compressor Flange 4. Cross Plate Figure 11-1 Air Compressor 3. Remove the cross plate between the compressor and the power steering pump. 4. Discard the O-ring between the power steering pump and the air compressor. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 11-3