Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

11.1 AIR COMPRESSOR FLANGE NOTICE: When removing the flange, make sure not to damage the crankshaft journal or crankshaft bearing. 5. Remove the four bolts attaching the air compressor flange to the air compressor housing. 6. Discard O-ring between the air compressor flange and air compressor housing. 7. Inspect air compressor flange, bearing, and O-ring surfaces for damage. Replace if necessary. 11.1.2 Installation of Air Compressor Flange Installation steps are as follows: 1. Install the new O-ring between the air compressor flange and air compressor housing. NOTICE: Make sure to not damage the crankshaft journal or crankshaft bearing while installing. 2.

Install the air compressor flange using the four bolts. Torque to 30 N·m (22 lb·ft). NOTE: Use grease to hold the cross plate in place while installing the power steering pump. 3. Install the cross plate. NOTICE: Make sure not to damage the bolt threads when installing the power steering pump to the air compressor. 4. Install the two bolts attaching the power steering pump to the air compressor. Torque to 40 N·m (30 lb·ft). All information subject to change without notice. 11-4 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION