Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 11.2 AIR COMPRESSOR The air compressor, with a power-steering pump attached, is driven by a gear on the camshaft. Perform the following procedures for removal and installation of the air compressor. 11.2.1 Removal of Air Compressor Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the coolant. 2. Remove the two bolts attaching the power steering pump to the air compressor. See Figure 11-2. 1.

Mounting Bolt 4. Cross Plate 2. Power Steering Pump 5. Air Compressor 3. O-ring 6. Hydraulic Lines Figure 11-2 Power Steering Pump NOTE: Do not remove the power steering lines. Tie up the lines and move the pump out of the way. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 11-5