Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

11.2 AIR COMPRESSOR 3. Remove the cross plate between the compressor and the power steering pump. 4. Remove the three air lines. See Figure 11-3. 1. Discharge Air Line 5. Intake Air Line 2. O-ring 6. Hose Clamp 3. 90° Elbow 7. Unloader Air Line 4. Air Compressor Figure 11-3 Air Line Attachments PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. [a] Remove the discharge (compressed air) line and the 90° elbow. Check inside the discharge line for carbon deposits. If deposits are found, replace the discharge line. NOTE: The 90° elbow on the discharge line must be removed to allow removal of the engine trim cover.

[b] Remove the unloader line. Check the fittings for damage and replace if necessary. [c] Loosen the hose clamp and remove the intake (suction) air line. 5. Remove the engine trim cover. Refer to section 1.1.1. NOTE: The bottom of the engine trim cover overhangs the coolant delivery line fasteners, making them difficult to remove. All information subject to change without notice. 11-6 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION