Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 12.2.1 Checking the Coolant Level (Hot Check) Check the coolant levels as follows: 1. Allow the engine to run for approximately five minutes at a moderate speed. HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 2. Then, with the coolant temperature above 50°C (122°F), recheck the coolant level. 3. Add more coolant if necessary. Open the heater valves before adding coolant. 4.

Do not close the heater valves until the engine has been run briefly and the coolant level again checked and corrected as necessary. 12.2.2 Starting an Engine That Has Not Been Run for a Long Time Before starting an engine which has not been run for a long time, certain special work must be carried out. NOTE: At outside temperatures below –20°C (–4°F), a coolant preheater is recommended. PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Chock the tires, place the transmission in neutral, and set the parking brake. 2.

Turn on the ignition switch and start the engine All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 12-9