EPA07 MBE 4000 SERVICE MANUAL 12.4 STOPPING THE ENGINE If the engine has been running at full output or the coolant temperature has been high, allow the engine to idle for one to two minutes without load. Then turn off the ignition switch. If any the following occur, shut down the engine immediately. The oil pressure swings back and forth or falls sharply. Engine power and rpm fall, even though the accelerator pedal remains steady. The exhaust pipe gives off heavy smoke. The coolant and/or oil temperature climb abnormally. Abnormal sounds suddenly occur in the engine or turbocharger. 12.4.1 Shutting Down After Hard Operation After hard operation, do the following: NOTICE:
After hard operation, allow the engine to idle for one to two minutes without load. Shutting down the engine without idling may cause damage to the turbocharger. 1. If the engine has been running at full output or the coolant temperature has been high, allow the engine to idle for one to two minutes without load. 2. Turn off the ignition switch and shut down the engine. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 12-13