Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 13.1 CHECKING THE VALVE LASH Checking steps are as follows: NOTE: Adjust the valve lash when the engine is cold. Wait at least 30 minutes after shutdown, even if the engine ran only a short time. Select a method for adjusting the valves. There are two acceptable methods for adjusting the valves, prior to checking the valve lash: In order, according to the timing sequence used for fuel injection (see Method One—Adjust Each Cylinder in Firing Order); By type of valve, depending on crankshaft position (see Method Two—Adjust All Valves Using Two Crankshaft Positions).See Figure 13-1 for the cylinder and valve layout on MBE 4000 engines.

Figure 13-1 Cylinder and Valve Layout All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 13-3