13.1 CHECKING THE VALVE LASH 13.1.1 Method One — Adjust Each Cylinder in Firing Order Method one allows you to adjust each cylinder in the order in which fuel is injected. The crankshaft must be repositioned after each cylinder is adjusted as listed in Table 13-1. Table 13-1 Valve Adjustment (Method One) NOTE: Clean each cylinder head cover before removing it. 1. Remove the cylinder head covers. Refer to section 1.2.1. 2. Remove the inspection cover on the flywheel housing. 3. Install the engine barring tool (J–46392) into the inspection hole on the flywheel housing. See Figure 13-2. 1.
Inspection Cover Figure 13-2 Placement of Engine Barring Tool All information subject to change without notice. 13-4 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Engine Crank- shaft Po- sition Cylinders Cylinders Cylinders Cylinders Cylinders Cylinders MBE 4000 Ignition TDC 1 5 3 6 2 4 MBE 4000 Valve Overlap 6 2 4 1 5 3