Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. For each cylinder, use the engine barring tool (J–46392) to turn over the crankshaft until the piston is exactly at top dead center (TDC) in the compression stroke. The valves must be closed and it must be possible to turn the pushrods without effort. NOTE: When the piston in cylinder #1 is at ignition TDC, the valves of cylinder #6 will overlap, meaning that both intake and exhaust valves are partially open, and show no measurable play when tested with a feeler gauge. 5. Check each valve and adjust it (if necessary), using the procedures under the heading "Adjusting Valve Lash." 6.

For each valve, measure the valve lash with an angled feeler gauge between the rocker arm and valve bridge. It should be possible to pull the feeler gauge through with light resistance. Table 13-2 Valve Lash Checking and Adjustment 13.1.2 Method Two — Adjust All Valves Using Two Crankshaft Positions Method two allows you to adjust all the valves using just two crankshaft positions. NOTE: Clean each cylinder head cover before removing it. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 13-5 Valve Type Adjust to: mm (inches) Intake 0.40 mm (0.016 in.) Exhaust 0.60 mm (0.024 in.)