EPA07 MBE 4000 SERVICE MANUAL 3. Attach the engine barring tool (J–46392) into the inspection hole on the flywheel housing. See Figure 13-4. 1. Inspection Cover Figure 13-4 Placement of Engine Barring Tool 4. Using the engine barring tool (J–46392), turn the crankshaft until cylinder #1 is at the ignition TDC position (all valves are closed) and cylinder #6 is at the valve overlap position (all valves are open). NOTE: When the piston in cylinder #1 or #6 is at ignition TDC, there will be a small beveled alignment mark visible through the inspection hole. See Figure 13-5. Figure 13-5 Flywheel Alignment Mark All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 13-7