Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

13.1 CHECKING THE VALVE LASH 5. Check the valves in the "Ignition TDC" row listed in Table 13-3, and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." * I= Intake Valve and E= Exhaust Valve Table 13-3 Valve Adjustment (Method Two) 6. Using the engine barring tool (J–46392), turn the crankshaft until cylinder #6 is at the ignition TDC position (all valves are closed) and cylinder #1 is at the valve overlap position (all valves are open). 7.

Using the same procedure, check the valves in the "Valve Overlap" row listed in Table 13-3 and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." 8. For each valve, measure the valve lash with a feeler gauge between the rocker arm and valve bridge. It should be possible to pull the feeler gauge through with light resistance. Table 13-4 Valve Lash Checking and Adjustment All information subject to change without notice.

13-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Engine Cylinder #1 Crankshaft Position Cylinder Valves/Types Cylinder *Valves/Types Cylinder *Valves/Types Cylinder *Valves/Type Cylinder s*Valves/Types Cylinder *Valves/Types 1 2 3 4 5 6 MBE 4000 Ignition TDC I/E I E I E — MBE 4000 Valve Overlap — E I E I I/E Valve Type Adjust to: mm (inches) Intake 0.40 mm (0.016 in.) Exhaust 0.60 mm (0.024 in.)