EPA07 MBE 4000 SERVICE MANUAL 13.2 ADJUSTING THE VALVE LASH Adjustment steps are as follows: 1. If adjustment is needed, unscrew the locknut. See Figure 13-6. Turn the adjusting screw until the valve lash is correct. Use the exact settings given in the "Adjust To" column listed in Table 13-4. 1. Adjusting Screw 2. Locknut Figure 13-6 Valve Lash Adjustment NOTE: When adjusting the valves, adjust to the exact setting. Use the range only for checking adjustment. 2. Tighten the locknut 50 N·m (37 lb·ft). 3. Check the valve lash again. Adjust again if necessary. 4. Install the cylinder head covers. Refer to section 1.2.2. 5.
Remove the engine barring tool (J–46392) from the inspection hole in the flywheel housing. 6. Replace the end cover on the inspection hole and tighten the bolts 25 N·m (18 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 13-9