Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

14.1 SCHEDULED INTERVALS 1. Loosen the bleed screw. See Figure 14-1. 1. Hand Pump 5. Pre-Filter Element 2. Separator Head 6. Sight Bowl 3. Bleed Screw 7. Drain Plug 4. O-ring Figure 14-1 Fuel /Water Separator 2. Unscrew the drain plug and drain the fuel in the pre-filter. 3. Twist off the sight bowl and remove the filter element from the separator head. 4. Separate the sight bowl from the filter element. Clean the sight bowl. Discard the old filter element and both O-rings. 5. Replace the filter element and O-rings. 6. Assemble the sight bowl and the pre-filter element. [a] Lubricate one O-ring with a light coating of engine oil. [b] Insert the lubricated O-ring into the sight bowl.

[c] Screw the pre-filter element and sight bowl together. 7. Assemble the pre-filter element and the separator head. [a] Lubricate the other O-ring with a light coating of engine oil. [b] Insert the lubricated O-ring into the open end of the pre-filter element. [c] Screw the pre-filter element onto the separator head and tighten firmly, using hands only. NOTE: Do not use tools to tighten the pre-filter element. All information subject to change without notice. 14-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION