Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 8. Insert the filter element into the pre-filter housing and screw the cap onto the housing. Tighten the cap 25 N·m (18 lb·ft). 9. Tighten the drain plug. 10. Prime the fuel system. Refer to section 12.1.5. 14.1.3 Removal of Fuel Filter Removal steps are as follows: FIRE To avoid injury from fire, keep all potential ignition sources away from diesel fuel, including open flames, sparks, and electrical resistance heating elements. Do not smoke when refueling. 1. Disconnect the batteries. 2. Open the fuel tank fill cap to release pressure in the fuel system. Replace and tighten the cap. 3. Clean the outside of the fuel filter housing. 4.

Using a 36-mm socket, unscrew the cap on the main fuel filter housing. Remove the cap and lift the filter element a short distance within the filter housing allowing the fuel to drain off the filter. Allow the fuel to drain off the filter into the housing. 1. Filter Housing Cap 3. Fuel Filter Element 2. O-ring Figure 14-2 Fuel Filter All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 14-9